Warning about Ammoload AND IMT brass!!!

A place to discuss calibers, ammunition, and reloading
Write comments

Re: Warning about Ammoload AND IMT brass!!!

Postby Ghost on Sun Jun 15, 2014 3:33 pm

Shot an ammoland reload mixed in with some freedom munitions reman that I bought and shot a while back. I was loaded near max in the hornady book using bullseye but I'm shooting it out of a Ruger Blackhawk that also shoots 357 mag. I see no signs of over pressure and it shot fine. I would have scrapped the round if I wasn't shooting it in this specific revolver.
User avatar
Ghost
 
Posts: 8246 [View]
Joined: Wed Feb 05, 2014 8:49 pm
Top

Re: Warning about Ammoload AND IMT brass!!!

Postby Seismic Sam on Mon Jun 16, 2014 8:59 am

Ghost wrote:Shot an ammoland reload mixed in with some freedom munitions reman that I bought and shot a while back. I was loaded near max in the hornady book using bullseye but I'm shooting it out of a Ruger Blackhawk that also shoots 357 mag. I see no signs of over pressure and it shot fine. I would have scrapped the round if I wasn't shooting it in this specific revolver.


Good call. Blowing up a Ruger Blackhawk with a 9mm round is probably about as likely as Obama nuking the road between Tikrit and Bagdhad today...
User avatar
Seismic Sam
Gone but not forgotten
 
Posts: 5515 [View]
Joined: Fri Jul 27, 2007 1:02 pm
Location: Pass By-You, Loosianana
Top
Previous
Write comments

Return to Ammunition & Reloading

Who is online

Users browsing this forum: No registered users and 4 guests

cron