Page 1 of 1

9mm

PostPosted: Tue Feb 11, 2020 5:36 pm
by fred666
I am having trouble loading 9mm i have a lee 4 hole turret press i just got the dies in place and every time i put a bullet in the shell (9mm .356 berry's bullets ) it puts the bullet to far into the case just the tip is showing any suggestions any help would be appreciated Thanks

Re: 9mm

PostPosted: Tue Feb 11, 2020 6:54 pm
by wasfuzz
I have nothing for you - but reach out to Oldman FCMSA or BigDog here they can probaly answer your question.

9mm

PostPosted: Tue Feb 11, 2020 7:50 pm
by gun_fan111v2
We will need a picture of this round.

How far does it go in if you push the bullet in by hand? How about against a table?

Re: 9mm

PostPosted: Tue Feb 11, 2020 7:58 pm
by BigDog58
fred666 wrote:I am having trouble loading 9mm i have a lee 4 hole turret press i just got the dies in place and every time i put a bullet in the shell (9mm .356 berry's bullets ) it puts the bullet to far into the case just the tip is showing any suggestions any help would be appreciated Thanks


If you are near Edina, I can give you a hand. I have a Lee 4- Hole Classic Turret and Lee dies. From your description, it sounds like you may not have your resizing die set correctly, or you could possibly be flaring your brass too much. One other reason could be you're seating die is pushing the bullet to deep, before you crimp the case. If I can help further PM me, and I'll send you my home number and I can possibly help talk you through it.

Jim