Wanted: Barrel Remington 1100 12 gauge 3 inch.

[tabberski]

I recently purchased a shotgun with a blown up barrel. So looking to replace this, and work up the project. Let me know what you have and how much. Just a fyi I dont want to get into this to deep. Not really worth it, if you know what I mean.

[Spike]

A 3" barrel is pretty short for a shotgun, eh?

[benny]

If you want to donate that blown up barrel to me for training props, I am looking for one.
I intend to mill off the chamber area just far enough to show how a 20 gage round will sit right in side the chamber and allow a 12 gage round to load in behind it.

I am currently working on getting all the NRA certified instructor classes completed by May.

I have one prop now with what the gun looks like after it is fired, but the chamber was blown out to bad to show how the 20 ga round can fit in it.
It is a Mosberg 500 pump with what was a cantelever scoped barrel.

The reciever was fine along with the bolt but the forearm,slide, mag tube,scope, and bottom of barrel were severly deformed and the top of the barrel was totaly blown apart from the breach to past the forcing cone.

Thanks, Benny

[MisterOblivious]

I recently purchased a shotgun with a blown up barrel. So looking to replace this, and work up the project. Let me know what you have and how much. Just a fyi I dont want to get into this to deep. Not really worth it, if you know what I mean.

I ended up with a pair of 30" 3inch vent rib fixed full choke barrels. Toss me a PM if one of those would work for ya.

[tabberski]

Still looking for a nice barrel. Must be able to shoot steel shot. Prefer 28 inch ribbed.