WTB AR-15 Pistol Barrel, Or Complete Upper **FOUND**

[Northfield 556]

Looking for a barrel for my AR pistol build. I may look at complete pistol uppers, if offered. I'm in Northfield and am willing to travel for the right deal. **FOUND**

[Northfield 556]

Still looking.

[HeadHunter]

Good luck, what length are you looking for? I've been looking for a 10.5"ish one myself but if your looking for shorter I might know where to find one....

[FJ540]

I can cut down and thread barrels if needed.

[snlit3]

I can cut down and thread barrels if needed.

How much

[FJ540]

$50 to cut a new gas block seat and drill gas port. $40 to cut, crown, and thread a barrel. That's for a bare barrel handed/shipped to me ready to machine.

So if you want a 7.5" barrel, first you need to make sure the barrel has enough meat to go down to .750 or .625 for the gas block, and it would be $90. If you just want to lop off the end of a 16" barrel it would be $40, but you'd get a 11 degree target crown out of it too.

I won't mess with a complete upper or front sight post. I don't want to be responsible for scratches or any issues with the barrel nut or taper pins.