Here's my hanger for a 2'x2' gong. Got all the construction & material ideas from the "DIY steel targets" thread on the old SnipersHide.
OldmanFCSA wrote:Have you had any of the welds broken yet?
Several steel targets I have shot, have had the welds broken by the vibration of plate being hit with umpteen thousands of ft/lbs of energy.
Also I would recommend that the plates be hung at a greater angle to project spatter into the ground instead of possibly back at you.
Doc Harvey wrote:If I may ask what I suppose will be an extremely stupid question....is it difficult to drill holes in 3/8" AR400 steel?
Doc Harvey wrote:If I may ask what I suppose will be an extremely stupid question....is it difficult to drill holes in 3/8" AR400 steel?
OldmanFCSA wrote:Doc Harvey wrote:If I may ask what I suppose will be an extremely stupid question....is it difficult to drill holes in 3/8" AR400 steel?
Zero your rifle with AP's, mark the plate where you need thru holes, shoot the mark. Note: you may need to deburr both sides after shot.
Users browsing this forum: No registered users and 2 guests