Want to Borrow - Torque Wrench

[MrVvrroomm]

...which requires 130 lb-ft of torque to prevent it from loosening ...

Ya know what 130 lb-ft = ? Real Effin Tight

[Inspiribomb]

...which requires 130 lb-ft of torque to prevent it from loosening ...

Ya know what 130 lb-ft = ? Real Effin Tight

Oh believe me, I know. I used to work at 3M, where we had to use torque multipliers to torque our extrusion dies down to spec. That, in addition to a 6' bar, and me sitting on it, to properly torque it. 130 lb-ft is nuts. Thank you Subaru.

[JoeH]

...which requires 130 lb-ft of torque to prevent it from loosening ...

Ya know what 130 lb-ft = ? Real Effin Tight

Oh believe me, I know. I used to work at 3M, where we had to use torque multipliers to torque our extrusion dies down to spec. That, in addition to a 6' bar, and me sitting on it, to properly torque it. 130 lb-ft is nuts. Thank you Subaru.

I've had a torque wrench for years. I can't remember the max (3/8" drive). I had to buy a BFTW (1/2" drive) for the axle nut on my Yamaha FZ1 (also 130lb-ft IIRC).