My brand New KelTec, PF9. Two rounds and..............

View · by **John S.** on Fri Mar 02, 2012 4:27 pm

JAM!

Second round case never left being half in and half out of the barrel.

Maybe it just needs broken in? Anyone else ever have prolems with a PF 9

View · by **infidel** on Fri Mar 02, 2012 4:30 pm

Fifty percent success rate can't be all bad.

View · by **Dill** on Fri Mar 02, 2012 4:31 pm

break it in. I'm assuming you cleaned and lubed it before shooting?

View · by **infidel** on Fri Mar 02, 2012 4:33 pm

Possibly could be limp wrist. Two rounds shot is not enough information. Shoot it.

View · by **Dill** on Fri Mar 02, 2012 4:50 pm

infidel wrote:Possibly could be limp wrist. Two rounds shot is not enough information. Shoot it.

they are really recoil sensitive. a locked wrist is highly recommended.

View · by **John S.** on Fri Mar 02, 2012 5:49 pm

Didn't kick like I expected, course shooting that SP101 .357 magnum kicked, this...................................................

not so much.

Yes I lubed it good. Not the barrel though, but, didn't think I should lube the barrel. Maybe after I clean it once it will get the

e gremlins out!

View · by **John S.** on Fri Mar 02, 2012 5:50 pm

Dill wrote:
infidel wrote:Possibly could be limp wrist. Two rounds shot is not enough information. Shoot it.

they are really recoil sensitive. a locked wrist is highly recommended.

That's all I fired, it locked up, and I had to go pick daughter up from school

, so never tried again.

View · by **Mdclinks** on Fri Mar 02, 2012 9:44 pm

Dill wrote:
infidel wrote:Possibly could be limp wrist. Two rounds shot is not enough information. Shoot it.

they are really recoil sensitive. a locked wrist is highly recommended.

^^^^^^^ what they said

View · by **gman1868** on Fri Mar 02, 2012 10:56 pm

The ammunition is a big factor. When my pistol was new, the Remington 9mm would cause all kinds of problems, jams, stovepipes, double-feed. They're really low-powered rounds.

Switched ammo, never had the problem again

View · by **MrVvrroomm** on Fri Mar 02, 2012 10:57 pm

I'll give you $50 for the POS

View · by **Humphrey Bogart** on Fri Mar 02, 2012 11:38 pm

Were you using the 'pinky extension' mag?

Try the Plus one round mag extension....I can't say enough about how it change the handleing of the gun....it means 3 full fingers on the grip instead of 2. Just do it

View · by **John S.** on Sat Mar 03, 2012 8:20 am

Mdclinks wrote:
Dill wrote:
infidel wrote:Possibly could be limp wrist. Two rounds shot is not enough information. Shoot it.

they are really recoil sensitive. a locked wrist is highly recommended.

^^^^^^^ what they said

And I thought the limp wrist comment was some kind of gay conotation.......................................... :shock:

View · by **Hammer99...** on Sat Mar 03, 2012 9:04 am

I broke mine in with 200 rounds of 115 gn American Eagle. I had two ftf. The primer was dinged by the pin. I totally blame the ammo. I did not clean or lube before I shot. The gun was new in box.

View · by **photogpat** on Sat Mar 03, 2012 9:15 am

An adequate break-in is rumored to be in the 200rds area. I know that I had several fail-to-feed/eject in through that area -- my pf9 is also ammo sensitive, it doesn't like the cheapo WWB 115gr -- instead preferring Federal AE9 FMH and HST JHP's...

View · by **Daddyo** on Mon Mar 05, 2012 7:18 am

I've never had any problems with mine since day 1.
I did the fluff and buff, http://thektog.org/tecwerks12a.htm, before the first firing.
I suppose limp wristing could be a problem, however my Ruger P89 has trained me well in recoil control. The shells eject almost straight up so if I don't control the recoil, I get thumped in the forehead.