I'm just getting into reloading and through various sources have what I believe to be enough 'stuff'. (This'd be for .45, 5.56, 45-70) I built a bench that measures 2' x 4' and its rock solid. I have two RCBS presses that I was thinking of using on the bench at the same time (my pseudo progressive method) and I was thinking of one on the far right and one on the far left.
Does that make sense? What's the best way to utilize my real estate on this bench?
Here's the stuff I see needing a footprint:
The 2x RBCS presses, manual powder dispenser, powder trickler, case trimmer, scale, shell casing block -for holding rounds in-progress, and all the misc small stuff (caliper, funnel, primer hand press, bullet remover, etc.
(the tumbler, powder, extra dies, and bulky stuff doesn't need to take up bench space)
Thanks in advance for suggestions on a practical layout,