Growing an ar15

[Hmac]

F Also if you haven't done it the 4mm set screw mod is easy for the detent on the takedown pin, 4mm setscrews can be located at Ace in Lakeville. I don't want to link to another forum but a little googlefu and you can find it.

If you're tapping with a 4-40 tap, don't you need 4-40 set screws rather than 4mm set screws? 4mm set screws are pretty big, quite a bit bigger than #4 set screws.

[Ghost]

F Also if you haven't done it the 4mm set screw mod is easy for the detent on the takedown pin, 4mm setscrews can be located at Ace in Lakeville. I don't want to link to another forum but a little googlefu and you can find it.

If you're tapping with a 4-40 tap, don't you need 4-40 set screws rather than 4mm set screws? 4mm set screws are pretty big, quite a bit bigger than #4 set screws.

Yeah, I messed up when I said that. The size should be 4-40 not 4mm.

[Hmac]

If you're tapping with a 4-40 tap, don't you need 4-40 set screws rather than 4mm set screws? 4mm set screws are pretty big, quite a bit bigger than #4 set screws.

Yeah, I messed up when I said that. The size should be 4-40 not 4mm.

http://www.amazon.com/dp/B0006O72M4/ref ... 00_TE_item

[unknown]

And so it ends

[samginko]

When are you planning on shooting your rifle?

[unknown]

Hey there,

I shot a mag at the gander range in Lakeville. The thing shot amazingly, but the range was too short and I didn't get enough time to sight. I will have to take it out shooting again soon