Review: Little Crow Gunworks W.F.T.

View · by **MaryB** on Sat Mar 21, 2015 6:57 pm

Now that I am reloading for an AR-15 I needed a better way to trim brass I buy to add to my stock. The Lee cutter leaves a LOT to be desired. Picked up one of the Little Crow Gunworks Worlds Finest Trimmer and I am impressed. Accurate clean cuts that will need no extra steps to debur etc. And fast, way faster than the putzy lee trimmer with having to chuck the case in the holder, trim, debur, chamfer...

With the WTF it is chuck it in the drill, grab a case and push it in, wait for it to stop cutting, done. I did 200 cases in an hour and that was with a lot of caliper use on cases that are to short.

View · by **bpacman** on Sun Mar 22, 2015 7:29 am

Hi Mary,

Did it take it done to 1.750 OAL?

When a friend of mine demonstrated the trimmer it was just short of 1.760.

Bp

View · by **PhilaBOR** on Sun Mar 22, 2015 7:32 am

Love that acronym.

View · by **Vlad** on Sun Mar 22, 2015 5:12 pm

That is the best part, it is adjustable. loosen the set screw that holds the end mill in place and move as needed.

View · by **jspace** on Sun Mar 22, 2015 7:34 pm

I have mine set at 1.751". It's spot on.
It was too much of a PITA to get it to 1.750".

View · by **MaryB** on Sun Mar 22, 2015 8:43 pm

Got mine at 1.49 and called it good. It is adjustable to any length you need. This will be a time saver because I just traded some engraving for 1,000 once fired cases(fired by the guy trading and someone I trust, no range pickup). Need to pickup some 55 grain bullets to load those with for range ammo. Still not happy with cast in the AR, works fine in the bolt rifle but getting the AR to cycle reliably is another story. Plus powder coating for the AR is a pain in the... with little 55 grain cast bullets.