H&R 22lr revolver project. The Thread

[mnglocker]

Tomorrow Slurpee is going to work some revolver-fu on it. Hopefully. Then it's off to Strad'n Vlad for grips and leather.

Good luck with it.....................

Thanks Gunny. Is that wish cause you want the Revolver for yourself. After all, it's for the children.

[hammAR]

Tomorrow Slurpee is going to work some revolver-fu on it. Hopefully. Then it's off to Strad'n Vlad for grips and leather.

Good luck with it.....................

Thanks Gunny. Is that wish cause you want the Revolver for yourself. After all, it's for the children.

If that's what it takes................

but it was meant for all of you working on this project as a BIG

[mnglocker]

Thanks Gunny. Is that wish cause you want the Revolver for yourself. After all, it's for the children.

If that's what it takes................

but it was meant for all of you working on this project as a BIG

Well, from one of the folks working on it, I say thank you all for trusting me not to bugger it up too badly.

And what's not to like about a wheel gun hammAR? sure it's kinda boring to shoot when comparing it to a 1911.

(After all, there's no malfunction drills to practice)

[mnglocker]

:bump: back to the top, I'm back begging for some help on this one, Slurpee (thank you Sir) and I spent a good five hours last night fitting the hand in this little thing to get the cylinder to advance. We now have the hieght right, but it needs to reach further.. So I'm here to beg someone to step up to the plate and order up another hand that I can "add" metal to via my welding apperatus. The part number is on the previous page, and if someone would like to help out that would be great. I'd order another myself, but I pretty well need to be able to buy groceries this month and that's a priority.

Just shoot me a PM if you have any questions.

[mnglocker]

:bump: What's the word Strad? Get some grips whittled yet? Bark side out?

[Stradawhovious]

:bump: What's the word Strad? Get some grips whittled yet? Bark side out?

Dropped of to Vlad for holster fitting, hopefully we can coordinate soon to get some grips on the beast. In addition to that, 45usp45 dropped off the part you were looking for, so I hope that helps. I will keep you posted!

[Vlad]

Strad got the gun to me and I am lovingly crafting a holster. The hope and plan is that I can get that done and then get back to Dan for final fitting of the Grips. I am going with a basic black with border tooling and perhaps an inlay of some exotic I have on hand. Tom

[mnglocker]

SWEEET!! A big thanks to Dave, Tom, Benny and Dan for their efforts so far.

[mnglocker]