Ok, I know, I'm taking up a lot of time, but I'm learning more here than any book, etc.
*Thanks btw on the tumbler cleaning answers)
So I went to deprime some rounds last night and after 9-10, one jammed in the decapping/sizing die. So I drilled and tapped and screwed it out. I went back and with a tiny tiny bit of PB Blaster on the round tried the press again. No go. It froze about 3/16" before 'seating' and the primer never budged. So I tried another round....same thing. (These are LC empties) So I tried IMI empties. Same thing. Look at the pic- is the die now shot for some reason? It seems like it wants to make it a .17!
I tried applying more presssure thinking I'm just being a puss, but the whole backside of the bench started lifting. What the heck? (The die is stamped 223 Rem) Thoughts?