Needed: Small piece of brass stock 1"x 3" x 1/8"

[Tomh]

I am fashioning a piece to hold in place switchable barrel on my great grand-dads shotgun / ball black powder shooter.

ImageUploadedByTapatalk1349216966.617037.jpg (30.72 KB) Viewed 1295 times

.

I have no idea where one might buy such a small piece. Hopeful a member may have a bit to sell. Please pm if so. Other ideas very welcome as well. Many thanks. Tom

[870TC]

Menards has some small pieces of brass. Near the screws/nails etc.

[Kskybroom]

Check at the Track of the Wolf in Elk River.
Black powder stuff might get lucky,,,

[FJ540]

I have a bunch of shim stock but it's only 5/8" wide - if that works, you can have what you need.

Located in Fridley.

[CarRacer]

I think this piece should get what you need. The ruler is 24" long. The piece is 1" wide on the bottom and you should be able to get the 1/8" and avoid the groove cut into it.

It's in Edina and you're supplying the elbow grease to cut it. The tools here suck too, so bring your own.

[Rem700]

Besides Menards you could check Ace Hdwr or a Hobby store usually sold in shortest IIrc 1ft pieces, all I have in hand is .070 & .250